How to Fit a BUSTER Design Collar Bones on Your Dog

Quick answer

To fit the BUSTER Design Collar Bones correctly, choose the right size based on your dog's neck girth, then secure the clic closure snugly but not tight, and adjust so the collar extends past the nose to prevent licking.

Step-by-step fitting guide

1. Step 1: Measure your dog's neck girth: Use a soft measuring tape around the base of the neck where the collar will sit. Add two fingers' width for comfort. The BUSTER Design Collar Bones comes in multiple sizes; choose the one where the neck opening matches this measurement. Common mistake: Choosing a size based on head size instead of neck girth can lead to the collar being too loose or too tight.
2. Step 2: Position the collar on your dog: Hold the collar with the wider end facing forward (toward the nose). Slide it over your dog's head so the neck opening rests at the base of the neck. The collar should extend past the tip of the nose by about 2-3 cm to prevent licking. Checkpoint: If the collar does not extend past the nose, the size is too small or it is not pushed back far enough.
3. Step 3: Secure the clic closure: Bring the two ends of the collar together under the neck and press the clic buckle until you hear a click. The collar should be snug enough that it cannot be pulled over the head, but loose enough that you can slide two fingers between the collar and the neck. Common mistake: Over-tightening can restrict breathing or cause rubbing; under-tightening allows the dog to shake the collar off.
4. Step 4: Check for movement and comfort: Gently try to rotate the collar on your dog's neck. It should not spin freely. Observe your dog for a few minutes to ensure they can eat, drink, and lie down comfortably. The transparent design lets you see if the collar is rubbing anywhere. Checkpoint: If the collar spins or causes red marks, adjust the fit or consider a different size.
5. Step 5: Monitor and adjust as needed: Check the fit daily, especially if your dog is still growing or losing weight. Clean the collar with mild soap and water as needed. Remove the collar during supervised periods only if your dog is not at risk of licking wounds. Common mistake: Leaving the collar on 24/7 without periodic checks can lead to skin irritation or pressure sores.

Product facts

• BUSTER Design Collar Bones 12.5cm Orange: The BUSTER Design Collar Bones is made of 100% polypropylene, flexible and easy to handle, with a transparent design and a quick clic closing system. The flexible material allows the collar to conform to your dog's shape while remaining sturdy enough to block access to wounds, and the transparency lets you see the affected area without removing the collar.